Added heat protection for electrodes.
Improved battery capacity measurement.
Startup clean is now on by default, start-up announced removed.
Dynamic distance check between fibers before splicing.
Dynamic motor limit check added.
Changed calibration process making it better and faster.
Dynamic calibration during splicing added.
When offset is larger than 10 show clean v-grove in yellow. if over 15 show in red. Max limit is 19um.
Added SD-Card bootloader, this will make it possible to update via sd card after this update has been installed. Instruction will be added with the next update. (In coming updates the splicer will also be able to act as an sd-card reader for your computer, work in progress)
Improved battery fault detection.
Shows hourglass during calibration, this can be switched off in the menu.
Change internal camera handling.
New algorithm for detecting the fibers vertical position.
Added support for new oven type.
Various secret tweaks and stability improvements.
Download link firmware: FW_3.06
Download link manual: EasySplicerUserManual_V3.00